ProPower 3000

Supreme Audio Power AC Regeneration With Battery Backup

 The ProPower 3000 battery back-up power re-generator quietly generates a new, clean, 120 volt 60 cycle sine wave right beside your audio or home theater system, so there is no opportunity for outside influences to introduce unwanted waveform distortions.  Your amplifier will play louder than if it was plugged into the wall outlet, delivering more slam on low frequencies and all the dynamics you’ve probably been missing. The 3000′s output of 3200 watts is more than enough to power dual monoblock, bi-amped, or tri-amped systems or Whole Home AV Racks. The 3000′s on-board battery system provides the reference voltage, as well as total isolation for your system from the utility power, regardless of whats occurring on the utility line.

Features

• 3000 VA/2100 watts continuous load, 3200 watts short duration, 6300 watts peak
• 25 amps RMS, 37 amps short duration, 75 amps peak
• 6 Hubbell 5-15/20R outlets, 2 Hubbell L5-20R locking outlets
• 30 amp power cord with L5-30P plug and wall receptacle included
  (Must have 30 amp circuit with #10AWG wiring from electrical panel)
• Designed for high power, whole home systems / 2 hour battery back-up

ProPower 3000 Specifications

Electrical Input: Nominal Voltage 220/230/240
Voltage Range: 160 - 275V
Frequency: 50 / 60 Hz Auto-sensing
Frequency range: 45-65 Hz
Input Connection: Hubbell NEMA L5-30P input receptacle (30 amp)
Electrical Output: output Voltage 220/230/240
Voltage Regulation: ±3% of nominal
Frequency Regulation: ±.1 Hz
Efficiency: 89-92% depending on load
Output receptacles: 6) Hubbell NEMA 5-15/20R +(2) Hubbell L5-20R
Physical Characteristics:
Floor or Rack mountable (racking hardware included)
Dimensions: 5.25″ H x 17″ W x 22.5″ D. (130x432x570mm)
Weight: 82 lbs (37 kg)
Environmental and Safety
UL and CSA
EMC monitors: FCC Class B and VCCI Class II
Surge Supression: IEEE / ANSI C62.41 Category B (formerly 587)
Ambient Operating Temp: 32 – 90° F (0 – 32°C)
Audible noise: >17 dBA
Relative humidity: 0 to 90% non-condensing
Additional Features
F-Type (coax) surge protection
Phone line surge protection: 1 line input, 2 lines output (on power strip option)
RJ 45 Transient protector: Input and output jack for RJ-45 cable protection,
UL497A tested (on power strip option)
Automatic bypass on sustained overload or AVPS failure
Diagnostics: Full system self-test on power up